OIL SOLUBLE DEMULSIFIER

• GUJCHEM OSD is a totally organic liquid formulation of surfactants and dispersants in a water and soluble in toluene ,Xylene, Aromatic solvent, crude oil for the demulsification of water in oil and oil in water.
  
  
• GUJCHEM OSD capable of performance at room temperature, but with improved speed and percentage of oil removed when applied at temperatures near 60 deg. C (140 deg. F).
  
  
• GUJCHEM OSD destabilizes the oil-water interface that surrounds each water particle in the emulsion, replaces the emulsifier molecules(if any), and allows the water to coalesce.
  
  
• GUJCHEM OSD is a completely combustible, non-abrasive, non-ash-forming treatment which will improve the quality of the fuel it is added too.

CHARACTERISTICS :

ADVANTAGES :

• Does not stay with the water phase, therefore does not contribute to water pollution
• Stays with the fuel and actually improves burning characteristics of the fuel
• Uses lower dosages than most competing products

DOSAGE :

Because of the diverse nature of oil and waste amenable to treatment with GUJCHEM OSD, specific recommendations have to be made on a case-by-case basis. The dosage of GUJCHEM OSD prescribed to break a particular emulsion varies from as little as 1 gallon per 20,000 gallons (50 ppm) of oil to as much as 1 gallon per 10,000 gallons (100 ppm) of oil. A few clients have even found that 20 ppm was more effective than the higher dosages, so we suggest adding the lower levels to your laboratory bench tests to verify the correct dosage for the specific application. Finding the most cost-effective dosage, as well as determining the best conditions of temperature, slow mixing, settling time, etc., is best done in the laboratory, using a sample of the actual oil or waste and a sample of GUJCHEM OSD

APPLICATION :

Once you have determined the correct dose of GUJCHEM OSD, fill the tank with the waste-oil-water solution and inject the correct dose of GUJCHEM OSD directly from the drum. Mix thoroughly, with the assistance of a pump, for two to five hours. Mixing time varies depending on the size of the tank and the speed of the motor. Allow the fuel to settle and check for water separation. Depending on the configuration of the tank, either remove the water by means of a drain in the bottom or suck the clean oil off from the top of the tank.

PACKAGING AND HANDLING :

GUJCHEM OSD is packaged in 55 gallon mild steel drums (208 liters) It contains a h aromatic solvent, and should be handled easily semi skilled workers.

Note: Above Gujchem Range are the running products. We can produce higher moles on customer specific demand and specifications can be altered as per customer requirement.